LED third brake light is a quick and simple way to upgrade the look of your pickup truck. When turned on, the bright LEDs (Light Emitting Diodes) shine up to ten times brighter than standard light bulbs. Even when the brake is not depressed, the integrated cargo light (if equipped) gives off plenty of white light to view your gear in the truck bed. The LED third brake light has a durable polycarbonate lens with a free form reflector and is available in Clear or custom Smoked.
Material: ABS Plastic/Polycarbonate Lens
Type: Third Brake Light
Style: Brake & Cargo Light
Bulb Type: LED
Voltage: 12V Operation
Housing Color: Black
Lens Color: Smoked
Light Color: Red/White
Low power consumption, plug-and-play operation
In comparison to OEM lighting, super LED lighting
It gives the vehicle a unique appearance that is ideal for show use.
No alterations or drilling are required, may require reuses OEM Hardware
Uses Existing Bolt Holes & Plug for Installation
Recommended to use hand screwdriver tool for the installation. Electronic tool can easily screwing too tight and crack the case.
For 1993-2011 Ford Ranger For 2001-2005 Ford Explorer Sport Trac For 1999-2016 Ford F-250 Super Duty For 1999-2016 Ford F-350 Super Duty For 1999-2016 Ford F-450 Super Duty For 1999-2016 Ford F-550 Super Duty For 1994-2010 Mazda B2300 For 1994-2001 Mazda B2500 For 1994-2008 Mazda B3000 For 1994-2003 Mazda B4000
Installation: The smoke lens will reduce light bulb brightness about 30%.
1 x Third Brake Light
The product does not come with manual/instruction, Professional Install Recommended
Cross Reference Number:
Cargo Light Function Note:
Should your vehicle is NOT equipped with a Cargo Light function but you still
wish to install?
You may experience the Cargo Light staying on ALL THE TIME. If you do experience
this issue, there are two modifications that may be performed
1. Disable the Cargo Light Function. This can be done by cutting the white 12v
Cargo Light power wire. If this is method is chosen it is recommended to cover
the wire end with heat shrink tube, wire nuts or electrical tape.
2. Add a switch and run a 12v power wire from your dash to the LED Brake Light.
This is will also require cutting the white 12v Cargo Light power wire. Again
please cover the plug side of the led wire to prevent electrical issues.
Prior to installation please verify the following:
1. Inspect back circuit board and wire connections
2. Verify circuit board is protected from exposed metal and wires when installing in the vehicle
3. Make sure the following wires are going to their correct locations.