Black Housing Clear Len Third Brake Light For 07-14 Sierra 1500/2500HD/3500HD

LED third brake light is a quick and simple way to upgrade the look of your pickup truck. When turned on, the bright LEDs (Light Emitting Diodes) shine up to ten times brighter than standard light bulbs. Even when the brake is not depressed, the integrated cargo light (if equipped) gives off plenty of white light to view your gear in the truck bed. The LED third brake light has a durable polycarbonate lens with a free form reflector and is available in Clear or custom Smoked.

• Material: ABS Plastic/Polycarbonate Lens
• Type: Third Brake Light
• Style: Brake & Cargo Light
• Bulb Type: LED
• Voltage: 12V Operation
• Housing Color: Black
• Lens Color: Clear
• Light Color: Red/White
• Low power consumption, plug-and-play operation
• In comparison to OEM lighting, super LED lighting
• It gives the vehicle a unique appearance that is ideal for show use.
• No alterations or drilling are required, may require reuses OEM Hardware
• Uses Existing Bolt Holes & Plug for Installation
• Recommended to use hand screwdriver tool for the installation. Electronic tool can easily screwing too tight and crack the case.

Application:

For 2007-2013 Chevrolet Silverado 1500
For 2007-2014 Chevrolet Silverado 2500
For 2007-2014 Chevrolet Silverado 2500 HD
For 2007-2013 Chevrolet Silverado 3500
For 2007-2014 Chevrolet Silverado 3500 HD

For 2007-2013 GMC Sierra 1500
For 2007-2014 GMC Sierra 2500 HD
For 2007-2014 GMC Sierra 3500 HD

For 2009-2010 Hummer H3T

Remark: Fit Models without Cargo Lights ONLY

Installation:

Product Content:

• 1 x Third Brake Light

The product does not come with manual/instruction, Professional Install Recommended

Cross Reference Number:

• BFC-3BRLED-GMCSIER07-BK

Cargo Light Function Note:

Should your vehicle is NOT equipped with a Cargo Light function but you still wish to install?
You may experience the Cargo Light staying on ALL THE TIME. If you do experience this issue, there are two modifications that may be performed

1. Disable the Cargo Light Function. This can be done by cutting the white 12v Cargo Light power wire. If this is method is chosen it is recommended to cover the wire end with heat shrink tube, wire nuts or electrical tape.

2. Add a switch and run a 12v power wire from your dash to the LED Brake Light. This is will also require cutting the white 12v Cargo Light power wire. Again please cover the plug side of the led wire to prevent electrical issues.

Prior to installation please verify the following:

1. Inspect back circuit board and wire connections
2. Verify circuit board is protected from exposed metal and wires when installing in the vehicle
3. Make sure the following wires are going to their correct locations.

• Black = Ground
• Red = Brake Light (+12v)
• White = Reverse Light (+12v)
• Yellow = Auxiliary or Running Light (+12v)